- 1 What should I look for in a deer topo map?
- 2 Do deer prefer ridges or valleys?
- 3 Where do big bucks hide?
- 4 Do deer like high or low ground?
- 5 How do you read elevation?
- 6 What do the numbers mean on a topo map?
- 7 How do you read a 7.5 minute quadrangle map?
- 8 Where do deer go during the day?
- 9 Where do bucks like to bed?
- 10 How far do deer travel from bedding area?
- 11 Do deer travel the same path every day?
- 12 What time of day are most big bucks killed?
- 13 What time of day is best to deer hunt?
What should I look for in a deer topo map?
While topo maps might seem like a pile of spaghetti on paper, those squiggly lines do mean something. In general, tightly-packed lines with minimal spacing represent steep terrain, while lines with a lot of space between depict flatter ground with little or a gradual change in elevation.
Do deer prefer ridges or valleys?
Ridges are used as travel ways and sometimes barriers by deer. Deer will generally not walk down the top of a ridge but will instead travel along the ridge a third or quarter of the way down, usually on the downwind side. This is likely a strategy to avoid being sky-lined to predators.
Where do big bucks hide?
Look for thickets, steep hillsides, deep draws, little swamps—out-of-the way spots where old boys might hide. The key to hunting one of these places is hidden, quiet access with a favorable wind, so you won’t blow out the bucks. Check your maps and scout further to pin down a good route in and out.
Do deer like high or low ground?
Most deer sign is found in low-lying areas, and because of that, many hunters set up there. However, the author has found that most of the time, you’re better off spending your time on a nearby ridgetop.
How do you read elevation?
To find an elevation, simply set the rod foot at any location on the job within the range of your laser or optical instrument. Run the detector and / or front rod section up or down until you pick up the “on grade” signal from your detector. Read the number opposite the pointer. That number is your true elevation.
What do the numbers mean on a topo map?
Contour elevation numbers indicate the direction of elevation by always reading (pointing) uphill. What is scale? Maps are made to scale. In each case, the scale represents the ratio of a distance on the map to the actual distance on the ground.
How do you read a 7.5 minute quadrangle map?
- Starting at the top right corner of the map, you will notice the map’s name and its series.
- Lines of longitude are called meridians.
- So a 7.5 Minutes Map will always cover roughly 8.5 miles of latitude (North to South) but a varying amount in longitude (East to West).
- The Bottom.
Where do deer go during the day?
Hiding in the Day
That is one of the main reasons why you don’t see them frolicking about so much during the day. Deer usually like to hide in thick bushes during the day, and they cover themselves up very well.
Where do bucks like to bed?
A southwest-facing slope provides two key elements a buck will look for in a bedding area: headwind and sunshine. This allows them to smell danger long before they see it and seek out a little warmth in the colder months. Mature bucks will typically lay down with a thick stand of trees at their backs.
How far do deer travel from bedding area?
However, when mature deer do feed during the day, it’s generally within 100 to 150 yards of their bedding area.
Do deer travel the same path every day?
Walking Along Paths
They leave their home going to a place they know they can feed and then walk back home. As long as this continues to be a safe place for them, they will continue to walk along this same path every single day.
What time of day are most big bucks killed?
Most of them are specifically between 9:00 and 10:00 in the morning to be exact. It’s a proven time, and it could have a lot to do with the common perception among deer hunters that things slow down once early morning is through.
What time of day is best to deer hunt?
No matter what the conditions, deer move best early of a morning and late of an afternoon. That’s when they’re wired to move most. It’s when their eyesight is most effective. And there are few things that impact this movement, other than pressure.